G750 – NOCO Genius G750 User Manual

Page 7

Advertising
background image

11

10

G750

geniuschargers.com

USING THE G750

USER INTERFACE

WICKED SMART TIP

ERROR CONDITION. An ERROR condition could happen for multiple
reasons. If an ERROR condition occurs, the ERROR LED and CHARGE
LED will blink “on” and “off” at 5Hz. For assistance in resolving
ERRORs, see the section entitled - TROUBLESHOOTING.

Now That’s Smart, Wicked Smart.™

MODE BUTTON

The MODE button is

used to select manually

between 6V or 12V

charging modes and

STANDBY.

ERROR LED

The ERROR LED

(Orange) will illuminate

when an error

condition or reverse

polarity is present.

CHARGE LED
The CHARGE LED indicates
the charging process. The
CHARGE LED will be RED
during the charging process
and will turn GREEN when
the battery is fully charged.

12V MODE LED

The 12V MODE LED

(Red) is illuminated

when the battery

charger is in the 12V

charging mode.

6V MODE LED

The 6V MODE LED (Red) is

illuminated when the battery

charger is in the 6V

charging mode.

STANDBY LED

The STANDBY LED

(Green) illuminates

when neither charging

mode has been

selected.

USING THE G750

HOW TO START CHARGING

1.) Confirm that you have connected the battery clamp or eyelet terminal
connectors properly and the AC power plug is plugged into an electrical outlet.
2.) The battery charger will begin in the STANDBY mode, indicated by a GREEN
LED. In the STANDBY mode, the battery charger is not outputting any current.
By pressing the MODE button, toggle to the appropriate charge mode, either
6V or 12V, to begin the charging process.
3.) Upon selecting either 6V or 12V charge mode, a RED LED will illuminate the
selected charge mode and the CHARGE LED (Red) will illuminate indicating the
charging process has started.
4.) When the battery is fully charged, the CHARGE LED will change from RED
to GREEN, indicating the charge process is complete.
5.) The battery charger can be left connected to the battery at all times to
provide maintenance charging. However, it is good practice to check the
battery periodically.

WICKED SMART FEATURE

AUTO-MEMORY. If at any time the battery charger is
disconnected from its power source, either from a power
loss or accidentally disconnecting the AC power plug from
the electrical outlet, the battery charger will remember the
previously selected charge mode when power is restored.
The battery charger will automatically resume the charging
process to ensure your battery is fully charged.

Now That’s Smart, Wicked Smart.™

WICKED SMART FEATURE

INITIALIZATION. When the battery charger is plugged into an AC
electrical outlet and connected to a battery, there will be a brief (one- to
three-seconds) delay, then all LEDs will light up for a half (1/2) second,
to confirm all LEDs are operational. After the initialization, the only LED
that will illuminate is the last mode selected. If not in STANDBY mode,
the battery charger will begin charging after five (5) seconds. The five (5)
second delay allows time to toggle through the charge modes.

Now That’s Smart, Wicked Smart.™

Advertising