NOCO Genius G750 - Manual (Page 9)

15 14
G750
geniuschargers.com
CHARGING STEPS
USING THE G750
Step 1: Diagnostics
Checks the battery voltage to make sure battery connections are good and the
battery is in a stable condition before beginning the charging process.
Step 2: Soft Start
Begins Bulk charging process with a gentle (soft) charge.
Step 3: Bulk
Continues Bulk charging process, returns 90% of battery capacity.
Step 4: Absorption
Brings the charge level to 100%. The battery charger will deliver small
amounts of current to provide a safe, efficient charge and limit battery gassing.
Step 5: Maintenance
Monitors the battery voltage continuously to determine if a maintenance
charge should be initiated. If the terminal voltage falls below approximately
6.4V (6V) and 12.8V (12V), the charger will start the Maintenance cycle
until voltage reaches approximately 7.2V (6V) and 14.4V (12V) and then will
discontinue the charge cycle. Maintenance cycle is repeated indefinitely to
keep the battery at full charge, without overcharging. The battery charger can
be left connected indefinitely.
USING THE G750
MAINTENANCE
CHARGING TIMES
The time required for the G750 to charge a normally discharged battery
is shown below. Deeply discharged batteries may take longer to charge
depending on the depth of discharge (DOD). The charge time is based on an
average depth of discharge to a fully charged battery.
*Note: The above table is for reference purposes only. Actual data may differ due to battery conditions. The
time required for the G750 to charge a normally discharged battery is based on an average DOD of 50%.
The G750 does not require any maintenance. Do not attempt to open or repair
the battery charger as it will invalidate the limited warranty. A damp cloth may
be used to clean dust, dirt, or other debris off of the battery charger. BEFORE
ATTEMPTING TO CLEAN THE BATTERY CHARGER, MAKE SURE YOU
REMOVE THE AC POWER PLUG FROM THE POWER SOURCE.
BATTERY SIZE
(Ah)
APPROX. TIME TO CHARGE IN HOURS*
6V 12V
1.2
2.2
7.2
14
25
30
1.5
2.5
8
15
27
33
1.5
2.5
8
15
27
33
WICKED SMART FEATURE
Now That’s Smart, Wicked Smart.™
ABNORMALITY PROTECTION. If the battery charger is
in the Bulk phase for more than 120 hours, the battery
charger will go into an ERROR condition. This feature
prevents damage if the battery is faulty.