Otter Outdoors Rod Holder User Manual
Otter Outdoors Hardware
Rod Holder Instructions Item 200067 (2990)
Tools needed:
7/16” Wrench
Phillips Screw Driver or Drill/Driver with Phillips bit
1. Attach rod holder bracket to fish house frame bracket using the machine screws. The
washer and nylock nut go on the backside. The bracket can also be mounted to any flat
surface. Substitute wood screws (not included) for the machine screws when attaching to
a wooden surface.
2. Insert rod holder into bracket. Adjust the tension of the rod holder with the thumb
screw. The tension at the joint may also be adjusted by tightening or loosening the
machine screw. Installation is complete.
Attach rod
holder bracket
here.
Machine
screws are
attached
here.
Thumb screw
is attached
here.
Insert rod
holder here.
Adjust joint
tension here.
Adjust rod holder
swivel tension with
thumbscrew.