Poly-Tex FB6001 User Manual
Page 3
Advertising
1. PLACE STABILIZER ONTO
HINGES AS SHOWN.
2. PLACE FLAT WASHER AS SHOWN AND INSERT COTTER
PIN THROUGH HOLE.
3. BEND ARMS OF COTTER PIN WITH PLIERS.
4. LINE UP FRICTION TABS ON PUSH NUT WITH THE SIDES
OF THE HINGE AND SEAT USING A HAMMER.
FRICTION
TABS
NOTE:
THE FOLLOWING STEPS ON THIS PAGE ARE ONLY REQUIRED FOR INITIAL ASSEMBLY. AFTER WASHERS,
COTTER PINS, AND PUSH NUTS ARE INSTALLED, IT IS NOT NECESSARY TO REMOVE THEM FOR STORAGE. FOR
STORAGE, THE BENCH ENDS ARE SIMPLY FOLDED FLAT OVER THE STABILIZER.
Advertising
See also other documents in the category Poly-Tex Gardening equipment:
- PX7001 (11 pages)
- PX7006 (9 pages)
- PX7020 (11 pages)
- PX7024 (10 pages)
- PX7026 (10 pages)
- PX7032 (11 pages)
- EC7001 (9 pages)
- EC7020 (9 pages)
- EC7025 (9 pages)
- EC7032 (9 pages)
- PX7003 (8 pages)
- PX7009 (10 pages)
- PX7021 (10 pages)
- PX7023 (10 pages)
- PX7025 (11 pages)
- PX7030 (11 pages)
- PX7040 (10 pages)
- EC7006 (8 pages)
- EC7022 (7 pages)
- EC7030 (8 pages)
- BD3000 (6 pages)
- BH3000 (6 pages)
- CD4000 (6 pages)
- CD3570 (8 pages)
- CH8000 (8 pages)
- EC3000 (4 pages)
- FB3003 (12 pages)
- FB3009 (8 pages)
- FB3020 (12 pages)
- FB3024 (8 pages)
- FB3025-4 (6 pages)
- FB3030 (6 pages)
- FB3040 (6 pages)
- HG2000 (4 pages)
- NT3000 (4 pages)
- NT3001 (4 pages)
- NT4500 (4 pages)
- PB3000 (2 pages)
- BW3000 (8 pages)
- BH4000 (6 pages)
- CD3000 (6 pages)
- CD8000 (6 pages)
- EC2000 (4 pages)
- FB3001 (14 pages)