Powermate KLA1581009 - Manual (Page 8)

8 200-2614
COMPRESSOR CONTROLS
DIGITAL CONTROL PANEL
On/Off button.
When the unit is plugged in and in the OFF mode, pressing this button
on the digital control panel turns the compressor on. It is operated man-
ually, but when in the ON mode, it allows the compressor to start up
and shut down automatically, without warning, upon air demand. The
on/off icon and the tool icon will be shown on the LCD display when the
unit is in the ON mode. ALWAYS turn the unit OFF when the compres-
sor is not being used, and before unplugging the compressor.
Pressure adjustment (up).
Pressing this button on the digital control panel increases the line pres-
sure to the tool you are using. Each time the button is pressed, it
increases the pressure by 1 PSI. Hold the button down to rapidly
increase the pressure. The maximum regulated pressure is 125 PSI.
Pressure adjustment (down).
Pressing this button on the digital control panel decreases the line pres-
sure to the tool you are using. Each time the button is pressed, it
decreases the pressure by 1 PSI. Hold the button down to rapidly
decrease the pressure.
Tank pressure indicator.
This indicator will be red when the tank is pressurized.
When there is zero tank pressure the indicator will not be visible.
Tank pressure button.
Pressing this button on the digital control panel will show the pressure
level of the air stored in the tank and the tank icon will be shown in the
display. It is not adjustable by the operator and does not indicate line
pressure.
Releasing this button will return the display to regulated pressure and
the tool icon will be shown in the display.
Adjustable pressure setting (default setting @ 40 PSI).
Pressing this button on the digital control panel will set the tank pres-
sure to a pre-set PSI (default setting is @ 40 PSI).
To change this pre-set pressure setting to a different PSI, adjust the
pressure to your desired setting by using the “+” or “-” buttons. Press
and hold the “1” button for 5 seconds. The displayed pressure will blink
3 times and then be stored as the new pre-set pressure for this button.
Adjustable pressure setting (default setting @ 90 PSI).
Pressing this button on the digital control panel will set the tank pres-
sure to a pre-set PSI (default setting is @ 90 PSI).
To change this pre-set pressure setting to a different PSI, adjust the
pressure to your desired setting by using the “+” or “-” buttons. Press
and hold the “2” button for 5 seconds. The displayed pressure will blink
3 times and then be stored as the new pre-set pressure for this button.
LCD Display window.
This display will automatically show the regulated outlet pressure when
the unit is on. The on/off icon and the tool icon will be shown on the dis-
play.
The display will automatically show the tank pressure when the unit is
off but still plugged in, if the pressure is not zero.
The bar on the right hand side of the LCD display window is a visual
indicator of tank pressure. When the bar reaches the top, the pressure
is at 155 PSI and the compressor will turn off. When the bar reaches
the bottom, the pressure is at 125 PSI and the compressor will turn on.
Change pressure display settings from “PSI” to “BAR”.
Press the On/Off button to turn the unit on.
Press and hold the On/Off button and the Tank pressure button at the
same time for 5 seconds to enter the display settings mode.
Press the pressure up “+” button to select the display to be in “PSI”.
Press the pressure down “-” button to select the display to be in “BAR”.
Wait for 5 seconds and the unit will memorize the selected setting and
turn off.
Restart the unit to view the unit operating pressure in the selected set-
ting.
Never Exceed the
maximum working pressure of the
tool. Press the “+” button to
increase pressure and the “-” button
to decrease pressure.
WARNING: