Qualcraft Seraph HUV Harness - Manual (Page 13)

Installation and Use
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
11
ALWAYS follow all instructions of all equipment used
in combination with Seraph Harness.
ALWAYS ensure all product-specific application specifications are met and adhered to.
NEVER attach connector to any place on harness other than D-ring.
Connector gate must be self-closing and self-locking, and must
withstand minimum load of 3,600 lbs.
ALL PFAS equipment must be selected and deemed compatible
with Seraph Harness by a Competent Person.
To connect Pass-Through Buckle, angle male buckle so
it is positioned to pass up and through female buckle.
Fully insert male buckle so that it lies flat on top of
female buckle.
To connect Tongue Buckle, pull webbing strap through
framed tongue component, and insert framed tongue
through grommet to secure.
Dorsal D-ring, chest strap, shoulder straps, and leg straps
MUST be fitted for each individual user.
To adjust dorsal D-ring, slide placard up or down webbing.
Dorsal D-ring must rest between the middle of the
shoulder blades.
Roller and Friction Adjustments allow the user to make
adjustments to Velocity Harness straps. Feed webbing through
buckle, and slide the buckle down on the strap to tighten, or
slide the buckle up on the strap to loosen.
Any excess strap webbing MUST be stored in harness Webbing Keepers.