Installation and use – Qualcraft Float Tux Harness User Manual
Page 13
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
11
Installation and Use
ALWAYS follow all instructions of all equipment used
in combination with the Float Tux Harness.
ALWAYS ensure all product-specific application specifications are met and adhered to.
NEVER attach connector to any place on harness other than D-ring.
Connector gate must be self-closing and self-locking, and must
withstand minimum load of 3,600 lbs.
ALL PFAS equipment must be selected and deemed compatible with
the Float Tux Harness by a Competent Person.
To connect Pass-Through Buckle, angle male buckle so it
is positioned to pass up and through female buckle.
Fully insert male buckle so that it lies flat on top of
female buckle.
Dorsal D-ring, chest strap, shoulder straps, and leg straps
MUST be fitted for each individual user.
To adjust dorsal D-ring, slide placard up or down webbing.
Dorsal D-ring must rest between the middle of the
shoulder blades.
Roller and Friction Adjustments allow the user to make
adjustments to harness straps. Feed webbing through buckle,
and slide the buckle down on the strap to tighten, or slide
the buckle up on the strap to loosen.
!
WARNING
Read and understand all instructions provided with PFD component
of Float Tux Harness; these instructions MUST be adhered to.
Quick Connect Buckles are activated by engaging two
release levers simultaneously to release the male piece
from the female receiver. Adjustments are made by
feeding webbing through the male end using a friction
style buckle.