Installation and use – Qualcraft Daytona Big Block SRL User Manual
Page 13
Installation and Use
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
11
LE SRL Additional Use Instructions:
Daytona Big Block SRLs are tested and certified for horizontal use over a steel edge without
burrs. Daytona Big Block SRLs may be used over similar surfaces, such as metal sheeting or other
steel formations.
The allowable angle of redirection of the lifeline portion of Daytona Big Block SRLs at the leading
edge of a fall hazard MUST be at least 90° (see Image 1).
Anchor point MUST be situated no lower than the leading edge of applicable fall hazard(s).
Prior to use, a Competent Person MUST calculate adequate fall clearance (see pg. 6).
ALWAYS attach to anchorage connector that will allow for required setback distance
(see Image 2).
Setback distance: As determined by product testing, Guardian Fall Protection Daytona Big
Block SRLs MUST be installed a MINIMUM 6’ (1.8m) from the leading edge of applicable
fall hazard(s).
ALWAYS adhere to the following warnings and specifications when using LE SRLs.
!
WARNING
Guardian Fall Protection Daytona Big Block SRLs may be used in Leading Edge (LE)
applications. Maximum free fall is 2’. ALWAYS avoid lifeline contact with sharp or abrasive
edges and surfaces. In Fall Arrest applications, anchorage connection point may be at
most 2’ below harness dorsal D-ring.
1. All PFAS components must be selected and deemed compatible with applicable SRL by a
Competent Person.
2. Ensure structure to which SRL is to be attached, and on which work is to be performed, is free
of all hazards, including, but not limited to, debris, rot, rust, sharp or abrasive edges and
surfaces, and hazardous materials.
3. Daytona Big Block SRLs may be used in stationary applications ONLY.
4. Attach Daytona Big Block SRL carabiner to selected anchorage connector, and attach snap
hook to applicable harness D-ring.
5. Ensure 100% tie-off will be maintained at all times, which may require the use of a back-up
or supplementary fall protection system.