AT&T E250 - Manual (Page 4)

2
LOW BATTERY
Battery installation & charging
Install batteries as shown, then place the handset in the charger for at least 8 hours
before use. You can keep batteries charged by returning the handset to the charger after
each use. When battery power is fully depleted, a full recharge takes about 6 hours.
Press coin into slot on
base of handset to
release latch, then
remove battery cover
Insert supplied
batteries
Place handset in charger to
charge for 8 hours before first use.
Light remains on while batteries
are charging.
Low battery indicator
Return handset to charger to recharge
when this symbol flashes. (Handset
will beep when battery is low.)
Caution: Use only AT&T 2AA
NiCad or NiMH rechargeable
batteries. Do not use AA
alkaline batteries.
Insert top
tab first
To replace battery cover
Press down to
click in place
REDIAL MEM MENU
Plug power cord into jack on underside
of charger, then plug transformer into
electrical outlet
ATT-250CIB-d1.qxd 12/30/2003 2:03 PM Page 2