Ramsey Winch ATV WIRELESS REMOTE FOR ATV - Manual (Page 7)

NOTE: For clarification see wiring schematic on page 5.
1. Connect red wire to center spade.
2. Connect green wire to the toggle switch terminal in the “OUT”
position.
3. Connect the yellow wire to the toggle switch terminal in the “IN”
position.
1. Locate accessory wire from ATV ignition.
NOTE: ATV accessory wire should have 12 volts only when
ignition key is on. Receiver should only have power when vehi-
cle ignition is ON.
2. Connect red wire with white stripe to accessory wire. Use sup-
plied quick splice connector if needed.
Wiring the Toggle Switch
Connecting the Power Lead
Installing the Antenna
NOTE: For clarification see wiring schematic on page 5.
1. Clean predetermined mounting surface with Isopropyl alcohol and
buff dry. (In ATVs without hoods the best place to mount the
antenna will be the underside of the ATV cowling in the highest
possible position.)
2. Remove backing from top side of double-stick tape and apply to
back side of pc board. Remove backing from other side of dou-
ble-stick tape and position pc board in center on top inside sur-
face of cowling or hood at the predetermined mounting location.
3. Remove backing from copper tape. Carefully affix tape to terminal
on right side of pc board and follow contour of inside of cowling.
DO NOT ALTER LENGTH OF THE TAPE. Repeat for left side.
4. Route coax cable up from receiver to antenna and plug in at pc
board.
4