Ramsey Winch ATV WIRELESS REMOTE FOR ATV - Manual (Page 8)

5
Programing instructions: Press and hold membrane below,
press ON/OFF button on transmitter for 3 seconds ,
press OUT button for 3 seconds or until winch activation .
WWW.RAMSEY.COM (918)438-2760 FAX(918)438-6688
Tulsa . Oklahoma, USA .
.
PUSH
BLACK WIRE
TO GROUND
YELLOW WIRE
SOLENOID ASS’Y.
BLACK W/ YELLOW
STRIPE MOTOR
LEAD
RED
BATTERY LEAD
BLACK
BATTERY LEAD
BATTERY
YELLOW WIRE
YELLOW
WIRE
GREEN WIRE
GREEN WIRE
BLACK MOTOR
LEAD
GREEN WIRE
WIRELESS
SIGNAL
RED WIRE W/
WHITE STRIPE TO
ACCESSORY WIRE
ON VEHICLE IGNI-
TION
RED WIRE
ANTENNA
RECEIVER
TOGGLE SWITCH
COAX CABLE
OUT
IN
Electrical Schematic
WIRING HARNESS
#1
MOTOR
#2
NOTE:
TORQUE SOLENOID
TERMINAL NUTS TO
35-40 IN-LBS.
MALE SPADE
CONNECTOR
FEMALE SPADE
CONNECTOR
E A
C
B
TRANSMITTER
For certain mounting applications, where the solenoid needs to
be mounted at the rear of the vehicle, switch the battery and
motor leads. In this case, connect the black w/yellow stripe
lead to the positive (+) terminal of the battery, and the longer
black lead to the negative (-) terminal. Connect the red lead
and the shorter black lead to the motor terminals.
WIRE
SPLICE