Ramsey Winch RCH 15K HOIST - Manual (Page 20)

19
ASSEMBLY OF OUTPUT CARRIER
Note: Item Numbers refer to Carrier parts list on page 18
1. Place output carrier #72 on flat clean surface.
2. Install spacer #78 into the carrier
3. Press in (3) Bearings #77 into gear #73. Repeat this process to install the bearings in the two
remaining gears.
4. Slide the gear #73 into position in the output carrier #72.
5. Insert a thrust washer #74 between gear #75 and output carrier #72 (both sides of gear).
Completely insert carrier pin #59 into carrier #56 using care to align the roll pin hole in carrier
pin #75 with the roll pin hole in the output carrier #72.
6. Drive roll pin #76 into output carrier #72 until roll pin #76 is flush with surface of the output
carrier #72.
7. Repeat this process to install the two remaining gears into the output carrier.