Ramsey Winch DC-300 RAM-LOK - Manual (Page 15)

13
11. Check cover bushing (item #8) for signs of wear. Replace
if necessary by removing old bushing and pressing new
bushing into place.
12. Check pinion gear on motor for signs of wear. If neces-
sary replace motor (item #51).
13. Check gears of spur gear shaft assembly for signs
of wear, replace if necessary. Press old gears from
shaft (item #21). Tap key (item #20) into keyway of
shaft (item # 21). Press shaft through gears so that
gears are centered on shaft and key.
14. Apply grease to end of shaft, opposite gear. Apply
grease to bushing in gear housing (item #18). Place
greased end of shaft through thrust washer (item #70)
and bushing in gear housing (item #18). Place gasket
(item #45) onto gear housing cover (item #8). Apply
grease to gear end of shaft and bushing in cover.
Place cover onto shaft and secure to housing with
fi ve (item #29) capscrews at the fi ve lower most
holes.
RE-ASSEMBLY