Ramsey Winch DC-300 RAM-LOK - Manual (Page 16)

14
15. Place winch, with gear housing
cover down, on work bench.
Drum shaft should be in vertical
position. Slide thrust washer (item
#69) over drum shaft and slide
downwards until washer rests on
gear housing. Set springs (item
#66) and drag brake disc (item
#42) into pockets of gear hous-
ing. Grease bushings in drum
(item #10). Slide drum assembly
onto drum shaft with drum jaws
upward.
16. Place thrust washer (item #70) over end of drum
shaft and slide downward until spacer rests on
drum. Press drum (item#10) downward to compress
springs in gear housing.
Insert keys (item #47) into keyways with sharp edge
of keys pointing outward notched end of keys upward.
A rubber or brass mallet will be needed to gently tap
keys into position.
Apply grease to keys and end of shaft. Place jaw
clutch (item #7) over end of shaft and slide jaw clutch
over keys.
Set clutch housing (item #17) over end of drum shaft.
Pull jaw clutch (item #7) upward, toward clutch hous-
ing, enough to allow yoke, in clutch housing, to fi t
properly in groove around jaw clutch.