Ramsey Winch DC-7/DC-7B - Manual (Page 10)

8
7. Check for signs of wear on gear teeth. If replacement of
gear is necessary gear must be replaced as follows:
a) Press gear (item #15) from shaft (item #23).
b) Examine shaft keys (item #22) and keyways. If dis-
tortion of keys and/or keyways is evident, shaft
and keys should be replaced.
c) Tap keys (item #22) fi rmly into shaft keyways.
Press shaft and keys through gear keyways until
end of keys, on long end of shaft are fl ush with
gear.
8. Remove seal (item #58) from back of gear housing
(item#19). Press bushing (item #31) from gear hous-
ing. Press new bushing and seal back into place.
9. ON DCX-7 & DCX-7B ONLY. Check drum bushing
(item #29) for signs of wear. Replace if necessary
by pressing old bushing from drum and pressing
new one into place.
10. Check end bearing bushing (item #29) for signs of
wear. If necessary, remove old bushing and press
new bushing into place.