Ramsey Winch DC-7/DC-7B - Manual (Page 11)

9
11.Check cover bushing (item #30)for signs of wear. Replace if
necessary by removing old bushing and pressing new bush-
ing into place.
12. Check motor for signs of wear. If necessary replace
motor (item #47)
13. Check gears (items #13 & #14) of spur gear shaft as-
sembly for signs of wear, replace if necessary. Press
old gears from shaft (item #25). Tap key (item #21)
into keyway of shaft (item #25). Press shaft through
gears so that gears are centered on shaft and key.
14. Apply grease to end of shaft, opposite gear.
Apply grease to bushing in gear housing
(item #19). Place greased end of shaft
through thrust washer (item #62) and bush-
ing in gear housing. Place gasket (item
#44) onto gear housing cover (item #9). Ap-
ply grease to gear end of shaft and bushing
in cover. Place cover onto shaft and secure
to housing with six (item #64) capscrews.