Ramsey Winch HD-234 User Manual
Page 11
6. Remove gear housing cover (item #4)
from gear housing (item #8) by
unscrewing capscrews (item #20).
Thread two of the capscrews into the
two tapped holes of cover and tighten.
This will pull the cover loose from the
gear housing.
Remove cover gasket (item #28) and
pull shaft (item #13), with gear
attached, and thrust washer (item
#41) from gear housing.
7. Check for signs of wear on gear teeth. If
replacement of gear is necessary, replace as
follows:
a) Press gear (item #6) from shaft (item #13).
b) Examine shaft keys and keyways. If distortion
of keys and/or keyways is evident, shaft and
keys should be replaced.
c) Use a soft hammer to gently tap keys (item
#30) into keyways. Press gear (item #6)
over shaft and keys. Gear must be centered over keys.
8. Remove seal (item #38) from back of
gear housing (item #8). Press bushing
(item #19) from gear housing. Press new
bushing and seal back into place.
9. Check drum bushings (item #16) for
signs of wear. Replace if necessary by
pressing old bushings from drum. Press
new ones into place.
11
6
4
20
28
13
41
8
30
6
13
30
19
8
38
18
5
18