Ramsey Winch HD-234 User Manual
Page 15
17. Place thrust washer (item #42) over end of drum shaft and slide downward until space
rests on drum. Press drum downward to compress springs in gear housing.
Insert keys (item #29) into keyways with sharp edge of keys pointing outward and
notched end of keys upward. A rubber or brass mallet will be needed to gently tap keys
into position.
Apply grease to keys and end of
shaft. Place jaw clutch (item #3)
over end of shaft and slide jaw clutch
over keys.
Set clutch housing (item #7) over
end of drum shaft. Pull jaw clutch
(item #3) upward, toward clutch
housing, enough to allow yoke, in
clutch housing, to fit properly in
groove around jaw clutch.
18. Insert plug (item #34) into bottom of gear housing. Permatex may be applied to threads
to help prevent leakage.
Pour 3/4 pint of Phillips SMP
80W-90, Mobil HD 80W-90,
Shell Spirax HD 80W-90, or
CITGO MP 80W-90 gear oil only
into housing through hole in top of
housing. Insert relief fitting (item
#32) into reducer (item #33).
Reducer should then be placed into
hole on top of gear housing.
Tighten fitting and reducer securely.
15
13
3
29
42
18
7
33
34
32