Ramsey Winch HD-P10000X - Manual (Page 14)

12
Insert springs (item #43) into pockets in back of brake piston.
Install roll pin (item #38) into new motor coupling (item #25) below bottom of spline teeth. Insert motor coupling,
engaging it with the discs and the input shaft.
Place gasket (item #28) on mounting surface of motor (item #30). Slide motor shaft into coupling. Attach motor to
motor end bearing housing using (2) capscrews (item #19) and (2) lockwashers (item #24). Evenly tighten to 49 ft-
lbs. (66 Nm) torque.
Install the counterbalance valve (item #45) to the motor using (4) capscrews (item #15) and (4) lockwashers (item
#23). Tighten to 17 ft-lbs (23 Nm).
Securely connect fittings (item #26) to motor end housing and counterbalance valve, and connect tube assembly
(item #44) to fittings.
Apply at least 550 PSI hydraulic system pressure to brake and verify that brake releases (winch drum will rotate).