Ramsey Winch HD-P8000 914184-0209 User Manual
Page 8
6
INSTRUCTIONS FOR OVERHAUL HD-P8000 SERIES WINCH
Take note of mounting configurations for proper mounting of parts during re-
assembly. Replace all gaskets, o-rings, and seals during re-assembly.
Disconnect tube (item #49) from elbow fittings (items #30) on bottom of end bearing
and counterbalance valve (item #50). Remove motor (item #34) from end bearing by
slowly unscrewing capscrews (items #22). CAUTION:
MOTOR IS UNDER SPRING
PRESSURE.
Check breather vent (item #33). Make sure it is not clogged. If oil is leaking from vent,
check brake o-rings, backup rings, and sealing surfaces (see page 7).
Remove springs (items #48) from pockets and inspect for damage.
Replace gasket (item #31).
Remove coupling (item #29) from end bearing. Examine coupling for signs of wear, re-
place if necessary. If necessary, remove counterbalance valve from motor by removing
capscrews (items #16).
22
28
34
31
29
16
26
50
49
30
48