Ramsey Winch RPH 50000 UW/TNR & 2 SPEED MOTOR - Manual (Page 15)

Set gasket #36 into place on gear housing end bearing #10. Place ring gear #49 onto end
bearing, aligning holes in ring gear with holes in gasket and gear housing end bearing. Use (2)
capscrews to temporarily secure ring gear to end bearing. Place (2) gear carrier assemblies into
ring gear meshing carrier gears with ring gear. Slide input sun gear over shifter shaft #12 and
mesh with teeth of input carrier. Apply grease to input thrust washer and place into slots of
gearbox cover #4. Place gasket #36 into position on gearbox cover with sealer. Remove (2)
temporary capscrews and attach cover and gasket to ring gear end bearing. Use (12) capscrews
#15 to secure gearbox to gear housing end bearing. Torque capscrews to 87 ft-lbs. each, in a
criss-cross pattern. 13.
10
36
12
15
47
36
4
49
13