Ramsey Winch RPH 50000 UW/TNR & 2 SPEED MOTOR - Manual (Page 9)

5. Pull drum assembly #1 upward from end bearing #10. Remove quad-rings #41 from grooves in
drum bushings. Remove input shaft #11, clutch springs #44 & #45 and washers #27 & #28 from
end bearing. Examine splined ends of input shaft for signs of wear, replace if damaged.
41 5
44
45
28
10
27
11
41
1
Examine drum assembly #1 for signs of wear. If splines inside of drum driver #1a are damaged,
drum driver must be replaced. Remove drum driver by unscrewing (8) capscrews #1e. If bushings
1c & 1d show signs of wear, replace by pressing old bushings from drum and removing o-rings 1f
& 1g from grooves in drum 1b and drum driver 1a. Place well-oiled o-rings into grooves in drum
and drum driver. Press new bushing into end of drum opposite drum driver and press bushing into
drum driver until flange of bushings are flush against drum and driver. 6.
1c
1f
1b
1g
1a
1f
1d
1e
7