Ramsey Winch CHEVY GRILL GUARD KIT 295933 - Manual (Page 2)

1
Step 1
Note: It is not necessary to remove or modify the vehicle bumper to install this mounting kit.
Remove the M12 nut to the cross bolt on the tow hook and slide the bolt back. Remove lower M12
bolt for tow hook on bottom of vehicle frame. It is not necessary to remove the tow hook.
Note: If vehicle is not equipped with tow hooks, use 5-1/2” and 1-1/4” long 7/16” capscrews (#14 and
15) to attach frame mounting brackets to vehicle frame. Installation will be similar to that shown in
Figures 3, 4, and 5, except that 5-1/2” capscrew should be inserted horizontally through vehicle
frame and 1-1/4 long capscrew should be inserted up into vehicle frame. Fasten with 7/16 flat
washers #24 and 7/16 lock nuts #20.
Step 2
Align L.H. frame mounting bracket #7 with underside of vehicle frame (Figure 3), slide tow hook bolt
back into place and secure with M12 nut (Figure 4). Make sure that tab on bracket is to the inside
edge of frame. Replace lower M12 mounting bolt (Figure 5).
DO NOT TIGHTEN HARDWARE
COMPLETELY.
Figure 1 Figure 2
Figure 3
Figure 4 Figure 5