Ramsey Winch FORD GRILL GUARD KIT 295368 - Manual (Page 3)

6. As shown at right, if the truck is equipped with fog
lights, remove clip for fog light electrical harness
from inside of frame. Tie off fog light electrical har-
ness further back.
7. Remove factory bolt and nut from frame and install
(1 per side) 7/16-14NC X 1-1/2” capscrew (Item
#11), 7/16 nut (Item 14), and lockwasher (Item
#16) with bolt reversed in frame (so that bolt is
pointing outward). Repeat for other side.
NOTE: Some models may not have these factory
bolts. If there is no factory bolt, skip this step.
8. Enlarge rectangular cutout in bumper bracket by 3/4”
at top and 1/4” at bottom as shown below. The fin-
ished bracket will appear as shown middle right.
9. Remove air dam.
10. Attach (1 each side) nut plate (Item #3) loosely to
inside of each Mounting Bracket Assembly (Items
#1 and #2) using (2 each side) 1/2-13NC X 1-1/4
capscrews (Item #9), (2 each side) washers (Item
#18), and (2 each side) lockwashers (Item #17) on
each assembly. See illustration at right.
3
REMOVE CLIP FOR
FOG LIGHT ELEC-
TRICAL HARNESS
REMOVE FACTORY BOLT
AND NUT. REPLACE
WITH SUPPLIED BOLT
AND NUT, REVERSED.