Ramsey Winch FORD GRILL GUARD KIT 295368 - Manual (Page 7)

20. Reinstall air dam.
21. Reinstall engine heater plug (if diesel model).
22. Reinstall splash guard.
23. Reinstall blocker bar.
24. Drill (2 each side) 9/16” holes through bumper
bracket using mounting bracket flange inside holes
as guides.
25. Using (2 each side) 1/2-13NC X 1-3/4 capscrews
(Item #7), (2 each side) lockwashers (Item #17), (1
each side) nutplate (Item #4), and 1/2” nut (Item
#13), bolt mounting bracket and bumper bracket to
vehicle frame.
26. Refer to Winch Owner’s Manual for instructions on
electrical connections. Be sure battery cables are
not drawn taut across any surfaces which could
possibly damage them.
27. Push battery cable into loom (Item #21) and slide
loom up cables as close as possible to mounting
frame assembly. Secure using cable ties (Item #19)
at each end of loom. To improve appearance, wrap
ends of loom with electrical tape.
28. Plug remote switch into receptacle on top of sole-
noid. Run winch forward and reverse to check con-
nections. Snap appropriate “IN” and “OUT” disk into
proper thumb cavity, after determining winch operat-
ing direction. Do not leave switch plugged in when
winch is not in use.
29. Place end of wire rope through fairlead and attach
clevis hook. Use clevis pin and cotter pin (furnished
with winch).
30. Tighten all remaining bolts to proper torque values
(refer to Torque chart below).
7
Bolt Torque, Torque,
Size ft-lbs. Nm
3/8-16 34 ft-lbs 46 Nm
1/2-13 87 ft-lbs 118 Nm
7/16-14 50 ft-lbs 68 Nm
12 mm 39 ft-lbs. 53 Nm
Torque Value Chart