Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295948 & 295949 - Manual (Page 4)

4
1. Bolt the Upper Mounting Bracket (item #5) to the underside of the
frame as shown using existing hardware. Attach the Upper Support
(item #7) to the Upper Mounting Bracket using (2 per side) 3/8 x 1-
1/2” capscrews (item #12), (2 per side) 3/8 locknuts (item #16),
and (4 per side) 3/8 flat washers (item #13). Do not tighten until
later.
2. The other end of the Upper Support (item #7) should protrude
through the grille as shown at right.
3. Lift center unit (item #1) into place between lower mounts (with cen-
ter unit inside the lower brackets).
Lift winch channel (item #2) between lower mounts. Place channel
and lower mount gaskets (item #20) between center unit and lower
mounts, and between channel and lower mounts. Secure using (2 per
side) 3/8 x 1-1/4” capscrews (item #10), (4 per side) 3/8 washers
(item #13), and (2 per side) 3/8 locknuts (item #16). Do not tighten
until later.
Secure upper supports to side plates using (1 per side) upper support
gasket (item #21), (1 per side) 3/8 x 1-1/4” capscrews (item #10),
(2 per side) 3/8 washers (item #13) and (1 per side) 3/8 locknuts
(item #16). Do not tighten until later.
Repeat steps 1 through 3 for other side.