Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295948 & 295949 - Manual (Page 5)

5
IF INSTALLING WRAPAROUND KIT #295949, FOLLOW STEPS 7-8,
OTHERWISE SKIP TO STEP 9
7. Place wrap shim (item #29) between Wraparound units and side
plates of center unit. Install right and left Wraparound units (items #23
and #25) to side plates of center unit using (3 per side) 1/4 x 1” cap-
screws (item #26), (6 per side) 1/4 flat washers (item #27), and (3
per side) 1/4 locknuts (item #28). Do not tighten until later.
8. Install right and left Headlight Grilles (items #22 and #24) to Wrap-
around units and side plates of center unit using (2 per side) 1/4 x 1
capscrews (item #26), (4 per side) 1/4 flat washers (item #27), and
(2 per side) 1/4 locknuts (item #28). Far end of Headlight Grilles snap
onto Wraparound units. Do not tighten until later.
9. If needed, install the License Plate Assembly (item #17) to the under-
side of the Channel (item #2) using (2) 1/4 x 1 capscrews (item
#11).
10. Align and tighten all bolts to proper torque (see chart at right).
11. Install the fairlead using hardware furnished with the winch. Refer to
winch owner’s manual for complete instructions. Tighten fairlead
mounting bolts to proper torque.
12. Install the winch in the Channel according to mounting instructions in
the winch owner’s manual, using hardware furnished with winch. Do
not tighten mounting bolts until electrical connections are complete.
13. Refer to winch owner’s manual for electrical connections. Push battery
cables into loom (item #25) and secure using cable ties (item #24) at
each end of loom. To improve appearance, wrap end of loom with
electrical tape.
Bolt Size
Torque,
ft-lbs.
Torque,
Nm
1/4-20 9.7 13
3/8-15 39 53
7/16 58 78
Torque Value Chart