Ramsey Winch RPH-15000T - Manual (Page 11)

OM-914020-0199-A
9
Remove o-ring (item #25) from motor end bearing (item #6). Dip new o-ring in oil and seat
into groove of end bearing.
Remove seal (item #29) from gear housing end bearing (item #5). Loosen nut (item #19) and
remove nylon setscrew (item #15) and remove ring gear (item #4) from gear housing end
bearing. Install ring gear and nylon setscrew and nut. Ring gear must be fully seated in gear
housing end bearing (item #5) and slot in ring gear must be aligned with clutch shifter hole.
Dip new seal in oil and install in gear housing end bearing, with sharp edge of seal outward.