Ramsey Winch HD-200 (JERR-DAN) - Manual (Page 11)

3. Remove motor and coupling (item
#27) from (item #3) adapter by
unscrewing two (item #23)
capscrews with lockwasher.
Remove key (item #11) from
worm shaft. Unscrew four
capscrews (item #19) and remove
adapter from gear housing.
Replace adapter seal (item #41)
and gasket (item #29).
4. Remove bearing cap (item #4) from gear housing by unscrewing
four capscrews (item #19). Remove worm (item #13) and bearings
(item #14) from gear housing. Use soft hammer to gently tap input
end of worm and drive worm and bearing from gear housing. Once
worm has been removed from housing, bearing can be pressed from
end of worm.
Check for signs of
wear or damage to
worm (item #13) and
bearing (item #14).
Replace if necessary.
5. Remove gear housing cover
(item #6) from gear housing
(item #10) by unscrewing
capscrews (item #18). Thread
two of the capscrews into the
two tapped holes of cover and
tighten. This will pull the cover
loose from gear housing.
Remove cover gasket (item
#30) and pull shaft (item #12),
with gear attached, and thrust
washer (item #45) from gear
housing.
8