Ramsey Winch HDG-350 (JERR-DAN) - Manual (Page 9)

7
5. Remove gear housing cover
(item #6) from gear housing
(item #10) by unscrewing
capscrews (item #18).
Thread two of the capscrews
into the two tapped holes of
cover and tighten. This will
pull the cover loose from gear
housing.
Remove cover gasket (item #30) and pull shaft (item #12), with gear
attached, and thrust washer (item #46) from gear housing.
6. Check for signs of wear on gear teeth.
If replacement of gear is necessary,
replace as follows:
a) Press gear (item #8) from shaft
(item #12).
b) Examine shaft keys and keyways.
If distortion of keys and/or keyways
is evident, shaft and keys should be
replaced.
c) Use a soft hammer to gently tap keys (item #32) into keyways.
Press gear (item #8) over shaft and keys. Gear must be centered
over keys.
7. Remove seal (item #42) from back of (item
#10) gear housing. Press bushing (item
#16) from gear housing. Press new bushing
and seal back into place.
8. Check drum bushings (item #15)
for signs of wear. Replace if nec-
essary by pressing old bushings
from drum. Press new ones into
place.