Ramsey Winch HDG-350 (JERR-DAN) {CURRENT} User Manual
Page 14
6. Check for signs of wear on gear teeth.
If replacement of gear is necessary,
replace as follows:
a) Press gear (item #11) from shaft
(item #18).
b) Examine shaft keys and keyways. If
distortion of keys and/or keyways is
evident, shaft and keys should be
replaced.
c) Use a soft hammer to gently tap keys
(item #44) into keyways. Press gear (item
#11) over shaft and keys. Gear must be
centered over keys.
7. Remove seal (item #55) from back of
(item #13) gear housing. Press bushing
(item #23) from gear housing. Press
new bushing and seal back into place.
8. Check drum bushings (item #22) for
signs of wear. Replace if necessary by
pressing old bushings from drum.
Press new ones into place.
9. Examine shifter assembly (item #2)
for damage to yoke. Yoke should be
firmly attached to shaft, yet, able to
swivel freely around shaft. Replace if
necessary.
Install new shifter assembly (item #2)
by placing end of shaft, opposite yoke,
through spring (item #60) and into
housing (item #14).
55
13
23
22
10
22
22
14
2
60
18
44
44
11
14