Ramsey Winch HDG-350 (JERR-DAN) {CURRENT} - Manual (Page 15)

10.Check cover bushing (item #22)
for signs of wear. If necessary
remove old bushing and press
bushing into place.
11.Apply grease to end of shaft,
opposite gear. Apply grease to
bushing in gear housing (item
#13). Place greased end of
shaft through thrust washer
(item #62) and bushing in gear
housing (item #13). Place gas-
ket (item #42) onto gear
housing cover (item #9). Apply
grease to gear end of shaft and cover bushing. Place cover
onto shaft and secure to housing with ten (item #26) cap-
screws. Tighten capscrews to 8 ft. lbs. (10.8 Nm.) each.
12.Press bearing (item #21) onto
worm (item #19). NOTE: Be sure
that thick shoulder of bearings outer
race (side with manufacturer's
name and part number) is out,
away from worm threads. Press
bearing and worm into gear hous-
ing. Slip gasket (item #40) onto
brake housing. Use four capscrews
(item #31) to secure brake housing to gear housing. TIGHT-
EN CAPSCREWS TO 8 FT. LBS. (10.8 Nm.) EACH. See
Re-assembling and Checking the Brake in this manual to
complete brake assembly.
12
21
31
40
16
19
16
21
9
22
RE-ASSEMBLY
13
62
18
42
26
9
11
15