Ramsey Winch RE 12000 OVERHAUL INSTRUCTIONS User Manual
Page 3
3
7. Check for signs of wear on gear teeth If replace-
ment of gear is necessary, replace as follows:
a) Press gear #13 from shaft #21.
b) Examine shaft keys and keyways. If distor-
tion of keys and/or keyways is evident,
shaft and keys should be replaced.
c) Use a soft hammer to gently tap keys #46
into keyways. Press gear #13 over shaft
and keys. Gear must be centered over
keys.
8. Remove seal #61 from back of gear housing #17.
Press bushing #27 from gear housing. Press new
bushing and seal back into place.
9. Check drum bushings #26 for signs of wear. Re-
place if necessary by pressing old bushing from
drum. Press new ones into place.
10. Examine shifter assembly #1 for damage to yoke.
Yoke should be firmly attached to shaft, yet, able
to swivel freely around shaft. Replace if neces-
sary by removing pin #56 from handle #14. Re-
move rubber plug #57 from housing. Unscrew
setscrew enough to allow shifter assembly to be
removed from housing.
Check clutch housing bushing #26 for signs of
wear. Remove if necessary by pressing old bush-
ing from housing #16 and pressing new one into
place.
Install new shifter assembly #1 by placing end of
shaft, opposite yoke, through spring #65 and into
housing #16. Attach handle #14 to shaft using roll
pin #56. Tighten setscrew #35, in housing,
enough to allow shifter assembly to operate prop-
erly, Replace rubber plug #57.
46
46
21
13
27
17
61
26
9
26
1
65
26
57
35
47
56
14
16