Reelcraft Series H37000 Hose Reels - Manual (Page 3)

Series H37000 Hose Reels
www.reelcraft.com Page 3
Replacing the swivel
CAUTION: Remove supply line pressure
before performing the following procedure.
1. Remove supply line from swivel.
2. Remove swivel assembly from inlet
shaft.
3. Install swivel assembly to inlet shaft by
reversing steps 1 and 2. Apply thread
compound to all threads.
Replacing the motor
CAUTION: Before replacing the motor,
remove all electrical power or air pressure
from motor.
1. Disconnect wiring/air lines from motor.
2. Remove bolts securing motor mounting
bracket to reel. Remove bracket (refer
to diagram on page 3).
3. Install swivel assembly to inlet shaft by
reversing steps 1 and 2. Apply thread
compound to all threads.
Replacing the chain
CAUTION: Before replacing the chain,
remove all electrical power or air pressure
from motor.
1. Loosen (do not remove) bolts securing
motor mounting bracket in place.
2. Remove chain master-link.
3. Remove chain master-link. Install new
chain by reversing steps 1 and 2
above.
ADJUSTMENT PROCEDURES
Adjusting the reel
1. Adjust reel drag by loosening or
tightening set screw on hub casting on
manual driven reel.
Adjusting the chain tension
CAUTION: Before adjusting the chain
tension, remove all electrical power or
air pressure from motor. Over-tensioned
(tightening) of chain results in reduced
motor life. Adjust to allow between 1/4 and
1/2 inch play in chain.
1. Loosen bolts (do not remove) securing
motor mounting bracket to reel.
2. Move motor mounting bracket and
motor until proper chain tension is
obtained.
3. Tighten motor mounting bracket bolts.
MODIFICATIONS
CAUTION: Remove electrical reel power
and release all pressure from hoses before
beginning any modification.
Motor mounting
If it is desired that the motor be mounted
on the opposite end of the hose reel:
1. Remove bolts securing motor mounting
bracket and sprocket to reel assembly.
2. Assemble components to other end of
reel.
(3) places
(4) places
(4) places
(6) places