Reelcraft Nordic Series 2000 Reels - Manual (Page 4)

Hose Reel Operations Manual
Page 4 www.reelcraft.com
REPLACE THE SWIVEL
CAUTION: Remove supply line
pressure before performing the
following procedures.
1. Remove supply line (2)
from the swivel (1) or
inlet.
2. Remove swivel (1) from
inlet shaft (3).
3. Install replacement swivel
by reversing steps 1 & 2.
REPLACING “U” CUP SEALS ON NORDIC SWIVELS
NOTE: For special swivels such as food grade, Catherine style reels,
and special purpose swivels, see attached exploded drawing and
parts list for special instructions for swivel repair / replacement.
1. Remove supply line (3) from inlet adaptor (1).
2. Remove all three bolts (2).
3. Pull seal from recess inside of inlet adaptor.
4. Examine new seal (5) and ring (4) to check for damage.
5. Moisten face of seal with lubricant and replace into inlet adaptor
(1).
6. Bolt adaptor back in place and re-install supply line.
REPLACING THE MOTOR
CAUTION: Before replacing the motor, remove electrical power and
fluid pressure from reel.
1. Loosen (do not remove) bolts (1) securing motor (2) to reel.
2. Slide motor and remove chain.
3. Remove bolts securing motor.
4. Install replacement motor.
REPLACING THE CHAIN
CAUTION: Before replacing the chain, remove electrical
power and fluid pressure from reel.
1. Loosen (do not remove bolts securing motor (2) to reel.
2. Remove chain master-link.
3. Install replacement chain (1).
4. Adjust chain tension by moving motor until properly
obtained. Over tensioning results in reduced motor life.
Adjust to allow between ¼” and ½” play in chain.
HOW TO ORDER REPLACEMENT PARTS
Please provide the following information:
1. Model number
2. Serial number
3. Part description and/or balloon number listed on the
front of this manual.
*Some parts may not be shown, in this case a detailed part
description will be required.