ADTRAN 600R User Manual
Page 105
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
103
L2 P
ROTOCOL
(ATM–NET–ATM) > C
ONFIG
> PVC C
ONFIG
> VCI
This is the ATM Virtual Channel Identifier that serves as an address for the virtual channel cell
transmissions between two devices. The range is
0-65355
. The default setting is
38
.
L2 P
ROTOCOL
(ATM–NET–ATM) > C
ONFIG
> PVC C
ONFIG
> C
ONNECTION
Select the physical and logical method of data transfer over the virtual path. There are three valid
connection entries:
R
OUTER
,
V35
, and
V
OICE
. Select
R
OUTER
to connect traffic from this PVC to the Total
Access 600 Series integral IP router. Select
V35
to connect traffic from this PVC to a V.35 interface on the
system. Select
V
OICE
to connect traffic from this PVC to a voice connection (on a DSX-1 or FXS
interface).
L2 P
ROTOCOL
(ATM–NET–ATM) > C
ONFIG
> PVC C
ONFIG
> S
ETUP
(R
OUTER
)
Use these menus to configure the router parameters for this logical connection from the router to the T1
interface. These menus are only applicable when the
C
ONNECTION
parameter is set to
R
OUTER
.
C
ONNECTION
(R
OUTER
) > S
ETUP
> P
ROTOCOL
Selects the data-link protocol for the PVC connection between the T1 interface and the router.
The choices are:
IP
(def) and
PPP
.
C
ONNECTION
(R
OUTER
) > S
ETUP
> M
ODE
Identifies how the data will be transferred through the Total Access 600 Series system. The
following choices are available:
R
OUTE
IP (def) – All IP data for this PVC is routed through the Total Access 600 Series
integral router.
B
RIDGE
A
LL
– All data for this PVC is bridged through the Total Access 600 Series system.
R
OUTE
IP/B
RIDGE
O
THER
– All IP data for this PVC is routed through the Total Access 600
Series integral router and all other data is bridged through the system.
C
ONNECTION
(R
OUTER
) > S
ETUP
> PPP S
ETUP
Provides PPP configuration parameters for the PVC. These menus are only visible when the
M
ODE
is set to
PPP
.
A
UTHENTICATION
Contains the required parameters for PPP peer authentication and for being authenticated
by the PPP peer. Authentication is applied between the unit and the PPP peer as
described in the submenus.