ADTRAN 600R User Manual
Page 61
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
59
SYSLOG using Terminal Mode
Another option for configuring syslog is using the terminal mode command log dump <logname>. The
logname must be all CAPS must match the listings below. The command will dump all messages for the
indicated log (
ALL L
EVEL
shows all log messages) stored in the internal log buffer to the command line
display.
S
YSTEM
C
ONFIG
> S
YSLOG
> ALL L
EVEL
This entry allows setting the default reporting level for all log entries. If
ALL L
EVEL
is a lower priority than
the individual log entry level,
ALL L
EVEL
overrides the individual log reporting level.
S
YSTEM
C
ONFIG
> S
YSLOG
> KERNEL L
EVEL
Minimum required level for sending KERNEL log messages. Kernel messages provide low-level status
information concerning the operation of the unit.
S
YSTEM
C
ONFIG
> S
YSLOG
> DHCP L
EVEL
Minimum required level for sending DHCP log messages. DHCP log messages provide status information
on IP addressing information concerning the DHCP server or clients.
S
YSTEM
C
ONFIG
> S
YSLOG
> NTP L
EVEL
Minimum required level for sending NTP log messages. Network Time Protocol log messages provide
information regarding the network time settings.
S
YSTEM
C
ONFIG
> S
YSLOG
> TFTP L
EVEL
Minimum required level for sending TFTP log messages. TFTP log messages provide status information
concerning firmware upgrades and configuration transfers utilizing the TFTP protocol.
S
YSTEM
C
ONFIG
> S
YSLOG
> TELNET L
EVEL
Minimum required level for sending TELNET log messages.Telnet log messages provide status
information concerning telnet requests and connections to the unit.
S
YSTEM
C
ONFIG
> S
YSLOG
> IP L
EVEL
Minimum required level for sending IP log messages. IP log messages provide information concerning IP
packets that are sent and received to and from the unit.
S
YSTEM
C
ONFIG
> S
YSLOG
> PPP L
EVEL
Minimum required level for sending PPP log messages. PPP log messages provide status information
concerning PPP packets and connections through the system.
S
YSTEM
C
ONFIG
> S
YSLOG
> NAT L
EVEL
Minimum required level for sending NAT log messages. NAT log messages provide status information
concerning Network Address Translation being performed by the system.