Maple Systems HMI5000HD - Manual (Page 11)

11 HMI5000HD Installation Guide
1010-1019 Rev 01 www.maplesystems.com
2. Route the power cable to the HMI power supply. The power
cable should not be any longer than necessary.
3. Install the power supply wires as follows (with colors shown for
Maple Systems cable P/N 6030-0009):
Color Power Supply HMI
Red +Output/+24V DC +24 V
Black
–Output/+24V DC return
GND
Shield Case ground
FG or
NOTE: The power connector on the HMI5000HD uses a 3-position
terminal block with screw-down clamps. Lugs are not required.
Panel Preparation
The HMI5000HD models mount directly on the enclosure’s backpanel or
sidepanel using 35mm DIN rail, or screwed directly to the panel with
user-supplied M4 or #8 panhead screws.
Mount the HMI to the Panel
Figure 5a: Installing the HMI to DIN rail
Push both tabs down, and place the
unit over the DIN rail. Then slide
the bottom tab up.