Maple Systems HMI5000HD - Manual (Page 12)

12 HMI5000HD Installation Guide
1010-1019 Rev 01 www.maplesystems.com
Figure 5b: Installing the HMI directly to the panel
Configuration Wiring
To configure the HMI using the EZwarePlus software, you will need the
correct configuration cable for your HMI. Please refer to the following
table for configuration (download) cable requirements.
HMI Model
Ethernet
Configuration
Cable (Crossover)
P/N 7431-0104
HMI5000HD X
Ethernet
If using a switch or router between the PC and the HMI, use a straight-
through or crossover cable as required by the switch or router.
Maintenance
Figure 6: DIP switch positions (power must be cycled on the HMI after the DIP
switches are changed to activate the selected mode).
Push the top tab up and the bottom
tab down to expose the mounting
holes.
Both switches shown
in the off position.