Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 3)

3/7
Relevant Standards
These devices have been manufactured in accordance with:
•
Standard EN 60079-0 (2009) and IEC 60079-0 Ed6 (2011): Explosive
atmospheres - Part 0: Equipment - General requirements.
• Standard EN 60079-15 (2010) and IEC 60079-15 Ed4 (2010): Explosive
atmospheres - Part 15: Equipment protection by type of protection “n”.
• Standard EN 60079-31 (2009) and IEC 60079-31 Ed1 (2008): Explosive
atmospheres - Part 31: Equipment dust ignition protection by enclosure
“t”.
Permitted zones of application
Refer to the section titled "Markings" to get information about the permitted
zones of protection and the types of protection.
•
GP4000 Series Graphic Operator Interface installed in zones 2/22
hazardous areas must be certified and bear the marking.
• Ensure with the marking that the terminals are compatible with the
conditions permitted for the hazardous area at the site where it is being
used.
DANGER
POTENTIAL FOR EXPLOSION
Install, use, and maintain these modules in accordance with:
•
Standard IEC 60079-14 Ed4 (2007): Explosive atmospheres - Part 14:
Electrical installations design, selection and erection.
• Standard EN 60079-17 (2007): Inspection and maintenance of
electrical installations in hazardous areas.
• Standard EN 61241-14 (2004): Electrical apparatus for use in the
presence of combustible dust, Part 14: Electrical apparatus protected
by enclosures. Selection, installation and maintenance.
• Edicts, by-laws, laws, directives, circulars, standards, regulations and
any other document relating to where the apparatus is installed.
Failure to follow these instructions will result in death or serious injury.