Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 16)

Chapter 1 Overview
1-3
• When connecting the CA3-ISO232-01, the 9 Pin's setting of COM port is required to be VCC.
COM port settings can be set with the GP-Pro EX or in GP's offline mode.
RS-232C
Isolation Unit
CA3-ISO232-01 *2,3
Switch setting
:RS-422
(9)
(9)
(11)
(9)
RS-422 Cable
CA3-CBL422/5M-01
COM Port
Conversion
Adapter
CA3-ADPCOM-01
Mitsubishi PLC A, QnA,
FX Series' 2 Port Adapter II
GP070-MD11
2 Port
Adapter Cable
CA3-MDCB11
RS-422 Cable
CA3-CBL422-01
Terminal Block
Conversion Adapter
CA3-ADPTRM-01
RS-422 Cable
(Prepared by user)
RS-232C Cable
CA3-CBL232/5M-01
Mitsubishi PLC Q-Series Link Cable
CA3-CBLLNKMQ-01
Omron PLC SYSMAC Link Cable
CA3-CBLSYS-01
Mitsubishi PLC Q-Series Connection Cable
CA3-CBLQ-01
RS-232C
Isolation Unit
CA3-ISO232-01
Switch setting
:RS-232C
GP Unit – Continued from the GP3000H Cable Connector
(8)
(8)
(8)
(8)
Siemens TTY Converter Cable
CA6-CBLTTY/5M-01
(12)
Host Controller
PLC etc.
GP3000H Soft-type 3 m
Direct-connect Cable (with connector)
GP3000H-CBLSD-3M
GP3000H Soft-type 5 m
Direct-connect Cable (with connector)
GP3000H-CBLSD-5M
GP3000H Soft-type 10 m
Direct-connect Cable (with connector)
GP3000H-CBLSD-10M
GP3000H Conversion
Adapter
AGP3000H-ADPCOM-01
GP3000H Hard-type 10 m
Direct-connect Cable (with connector)
GP3000H-CBLHD-10M
(3)
(4) (5)
RS-232C Cable
CA3-CBL232/5M-01
Mitsubishi PLC Q-Series
Link Cable
CA3-CBLLNKMQ-01
Omron PLC SYSMAC
Link Cable
CA3-CBLSYS-01
(8)
(8)
(8)
(8)
(12)
Siemens TTY Converter Cable
CA6-CBLTTY/5M-01
Host Controller
PLC etc.
Mitsubishi PLC Q-Series
Connection Cable
CA3-CBLQ-01
Continued Continued