Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 44)

Chapter 2 Specifications
2-15
‹ Removal
(1) Unlock the connector that has been locked in the mounting procedure. (Turn the lock ring as shown so
that the small
U
mark is displaced from the
V
mark). Then, pull out the cable by holding the cable
connector.
• To disconnect the cable, be sure to hold the cable connector and pull it out. If you hold other
parts of the cable (lock ring, etc.), the cable cannot be disconnected.
2. Pull out the cable by holding the cable connector.
1. Turn the lock ring to unlock the connector.