1 software configuration, 2 setting up an hdd with no pre-installed os, 1 setting up the os – Proface APL3000B - Node Box PC User Manual
Page 9: 2 setting up the ps-a dedicated software, 1 software configuration -2, 2 setting up an hdd with no pre-installed os -2, 1 setting up the os -2, 2 setting up the ps-a dedicated software -2, Software configuration, Setting up an hdd with no pre-installed os
PS-3650A / PS-3651A Reference Manual
1-2
1.1
Software Configuration
If you purchased a PS-A unit with the OS pre-installed, the software has been pre-installed.
If you purchased a PS-A unit without the OS pre-installed, you can download each software program from the
Pro-face support site "Otasuke Pro!".
1.2
Setting Up an HDD with no Pre-installed OS
First, when you use a PS-A with no pre-installed OS, you will need to install Windows
®
XP. You also need to
install any required utility software.
1.2.1
Setting Up the OS
Install your operating system. For the setup procedures about the OS, refer to that product’s installation man-
ual.
1.2.2
Setting Up the PS-A Dedicated Software
Download the necessary drivers and utility software from the Pro-face support site “Otasuke Pro!”.
SEE
1.2.2 Setting Up the PS-A Dedicated Software (page1-2)
• You will need the Serial ATA controller driver to install the OS. Download the Serial
ATA controller driver from the Pro-face support site "Otasuke Pro!".
• The PS-A unit supports Windows
®
XP Service Pack 2. The PS-A unit performance
cannot be guaranteed when any other operating system is used.
•
The setup requires a USB keyboard.
•
For details about the drivers and utility software, refer to the following section.
SEE