Watlow EZ-ZONE RME - Manual (Page 12)

Watlow EZ-ZONE ® RME Module • 9 • Chapter 1 Overview
Module Orientation
The picture below represents one of six possible RM
modules. All six will have four slots on the face (slot
A, B, D, and E) and one on the bottom (slot C) not
shown. All of these slots are not always used on all
modules. On the face of the module there is a button
(white circle) under the Zone address (5) that when
pushed and held has the following functions:
1.For any module, push and hold for ~ 2 seconds. The
address will intensify indicating that it can now be
changed. Release and repeatedly press to change
to the desired unique address. Valid addresses over
Standard Bus range from 1 -16 (1 - 9, A is 10, B is
11, C is 12, D is 13, E is 14, F is 15, and h is 16).
The Access module is shipped at address J or 17
A
D E
B
Module Status (Slot A,
B, D, or E)
Protocol (Standard
Bus - red
Module outputs 1
through 16, all may
or may not be used
depending on module
type