Watlow CLS200 User Manual
Cls200 series user’s guide
Advertising
CLS200 Series
User’s Guide
Watlow
1241 Bundy Boulevard
Winona, MN 55987
Customer Service:
Phone........1-800-414-4299
Fax.............1-800-445-8992
Technical Support:
Phone........+1 (507) 494-5656
Fax ............+1 (507) 452-4507
Email [email protected]
Part No. 0600-3050-2000 Rev. A
November 2008
Advertising
Table of contents
Document Outline
- Title
- Warranty
- Table of Contents
- List of Figures
- List of Tables
- System Overview
- Installation
- Using the CLS200
- Setup
- How to Access the Setup Menus
- Setup Global Parameters Menu
- Load Setup From Job
- Save Setup to Job
- Job Select Digital Inputs
- Job Select Digital Inputs Active
- Output Override Digital Input
- Override Digital Input Active
- Startup Alarm Delay
- Keyboard Lock Status
- Power Up Output Status
- Process Power Digital Input
- Controller Address
- Communications Baud Rate
- Communications Protocol
- Communications Error Checking
- AC Line Frequency
- Digital Output Polarity on Alarm
- EPROM Information
- Setup Loop Input Menu
- Setup Loop Control Parameters Menu
- Setup Loop Outputs Menu
- Enable or Disable Heat or Cool Outputs
- Heat or Cool Output Type
- Heat or Cool Cycle Time
- SDAC Mode
- SDAC Low Value
- SDAC High Value
- Heat or Cool Output Action
- Heat or Cool Output Limit
- Heat or Cool Output Limit Time
- Sensor Fail Heat or Cool Output
- Heat or Cool Thermocouple Break Output Average
- Heat or Cool Linearity
- Setup Loop Alarms Menu
- High Process Alarm Setpoint
- High Process Alarm Type
- High Process Alarm Output Number
- Deviation Alarm Value
- High Deviation Alarm Type
- High Deviation Alarm Output Number
- Low Deviation Alarm Type
- Low Deviation Alarm Output Number
- Low Process Alarm Setpoint
- Low Process Alarm Type
- Low Process Alarm Output Number
- Alarm Deadband
- Alarm Delay
- Manual I/O Test
- Extruder Control
- Enhanced Features
- Ramp/Soak
- Features
- Ramp/Soak Menus
- Setup Global Parameters Menu
- Setup Ramp/Soak Profile Menu
- Edit Ramp/Soak Profile
- Copy Setup From Profile
- Tolerance Alarm Time
- Ready Segment Setpoint
- Ready Segment Edit Events
- External Reset Input Number
- Edit Segment Number
- Segment Time
- Segment Setpoint
- Edit Segment Events
- Edit Segment Triggers
- Segment Tolerance
- Last Segment
- Repeat Cycles
- Setpoints and Tolerances for Various Input Types
- Using Ramp/Soak
- Tuning and Control
- Troubleshooting and Reconfiguring
- Linear Scaling Examples
- Specifications
- Glossary
- Index
- Menu Structure
- Declaration of Conformity