Watlow CLS200 - Manual (Page 72)

Chapter 3: Using the CLS200 CLS200 Series User’s Guide
56 Watlow Anafaze Doc.# 0600-3050-2000
Table 3.2 explains the control status symbols on the bot-
tom line of bar graph display. Additional symbols may ap-
pear with the ramp/soak option. See Bar Graph Display on
page 146.
Table 3.2 Control Status Symbols on the Bar
Graph and Single Loop Displays
Navigating in Bar Graph Display
When the bar graph display is visible:
• Press the YES (up) or NO (down) key to see a new group
of loops.
• Press
ENTER twice to scan all groups of loops. The
groups will display sequentially for three seconds
each. This is called scanning mode.
• Press any key to stop scanning.
• Press
BACK once to go to the job display, if enabled, or
the single loop display.
Bar Graph
Display
Symbol
Single
Loop
Display
Symbol
Description
M MAN One or both outputs are
enabled. Loop is in manual con-
trol.
A AUTO
Only one output (heat or cool) is
enabled. Loop is in automatic
control.
T TUNE The loop is in autotune mode.
H
T HEAT Both heat and cool outputs are
enabled. Loop is in automatic
control and heating.
C
L COOL Both heat and cool outputs are
enabled. Loop is in automatic
control and cooling.
(blank) (blank)
Both outputs disabled, or input
type is set to SKIP.