Watlow CLS200 - Manual (Page 85)

CLS200 Series User’s Guide Chapter 3: Using the CLS200
Doc.# 0600-3050-2000 Watlow Anafaze 69
• A process alarm occurs and is unacknowledged. The
global alarm occurs only if the alarm type is set to
ALARM in the SETUP LOOP ALARMS menu. (The global
alarm does not occur if the alarm function is set to
CONTROL.)
The global alarm output stays active until all alarms have
been acknowledged.
When the global alarm output is active, it conducts current
to the controller’s dc common. When the global alarm out-
put is not active, it does not conduct current.
NOTE! You cannot configure any parameters for the
global alarm. The active state of the global
alarm output is NOT affected by the
DIG OUT
POLARITY ON ALARM
polarity parameter in the
SETUP GLOBAL PARAMETERS
menu.
Ramp/Soak
If you have a controller without the Ramp/Soak option,
pressing the
RAMP/SOAK key has no effect.
If you have a controller with this option installed, see
Chapter 7, Ramp/Soak.