Watlow CLS200 - Manual (Page 67)

Doc.# 0600-3050-2000 Watlow Anafaze 51
3
Using the CLS200
This chapter explains how to use the keypad and display to
operate the controller. Figure 3.1 shows the operator
menus and displays accessible from the front panel.
To change global parameters, loop inputs, control parame-
ters, outputs, and alarms using the setup menus, see Chap-
ter 4, Setup.
Figure 3.1 Operator Displays
Power
Bar Graph
Display
Single Loop
Display
Job
Display
BACK
BACK
Scanning
Display
ENTER
ENTER
Any
Key
Scanning
Single Loop
Display
ENTER
ENTER
Any
Key
Bar Graph
BACK
RAMP
SOAK
BACK
Change
Setpoint
CHNG
SP
Ramp/Soak
MAN
AUTO
BACK
on
BACK
Manual,
Automatic
or Autotune
Mode
Heat/Cool
Output
BACK
Percentage
(Manual
mode only)
ENTER
(Manual)