Watlow CLS200 - Manual (Page 119)

CLS200 Series User’s Guide Chapter 4: Setup
Doc.# 0600-3050-2000 Watlow Anafaze 103
Alarm Delay
Set a loop alarm delay. This parameter delays failed sensor
and process alarms until the alarm condition has been con-
tinuously present for longer than the alarm delay time.
Selectable range: 0 to 255 seconds.
Manual I/O Test
This menu facilitates testing of:
• Digital inputs
• Digital outputs
• The keypad buttons
Table 4.14 shows the screens available in the
MANUAL I/O TEST menu.
Table 4.14 Manual I/O Test
NOTE! The DIGITAL OUTPUT NUMBER screen ap-
pears only if an unassigned output has been
selected in the TEST DIGITAL OUTPUT
screen.
Digital Inputs
View the logic state of the eight digital inputs as H (high)
meaning the input is not pulled low, or L (low) meaning the
input is connected to the controller common.
Parameter
Default
Value
DIGITAL INPUTS HHHHHHHH
TEST DIGITAL OUTPUT? 1: IN USE
DIGITAL OUTPUT NUMBER XX? OFF
KEYPAD TEST N/A
ALARM
01 ALARM DELAY ?
0 SECONDS
ALARM
MANUAL I/O
TEST ?