Watlow MICRODIN - Manual (Page 10)

10
Watlow MicroDIN Quick Start Guide
Mounting the MicroDIN on a DIN rail
To Mount MicroDIN
1. Push unit in and down to catch rail hook
on top of rail.
2. Rotate bottom of unit in toward rail.
3. Rail clasp will audibly “snap” into place.
If the MicroDIN does not snap into place,
check to see if the rail is bent.
To Dismount MicroDIN
1. Press down on back of controller until the
bottom hook clears the rail.
2. Then rotate bottom up and away from
rail.
Figure 10a -
Mounting a MicroDIN
controller on a DIN rail
Figure 10b-
Dismounting a MicroDIN
controller from a DIN rail
①
①
➁
➂ "Snap"
➁